Glass Bead Sterilizer SMI-239

Jindal Glass bead sterilizer follows a scientific method for total sterilization of your instruments within 5 to 15 seconds. These sterilizers are compact state of the art, steam less non hazardous equipment for your clinic. It is a simple device for quick sterilization of small instruments with effective thermal sterilization. In this the clear glass beads are used in the well. The temperature of the glass beads sterilization is 240°C. The high precision temperature controller with over temperature protection is an added advantage. The instruments are dip in the glass beads for the quick sterilization.

Effective thermal insulation keeps the outer cover cool while keeping an even temperature inside the well. The heat loss is very low thus leading to very low power consumption.

Model

BS-01

BS-02

Temp.ControlRange

100℃~300℃

100℃~300℃

Temp.Stability

≤±5℃

≤±5℃

HeatingSpeed

≤25min

≤25min

HeatingWellVolume
(diameterxdepth)

Φ40x80mm

Φ40x150mm

GlassBeadsCapacity

300g

600g

CoverMaterial

StainlessSteel

StainlessSteel

InsulationMaterial

MineralWool

MineralWool

Voltage

AC220/AC110V,50/60Hz

AC220/AC110V,50/60Hz

Power

120W

300W

Fuse

250V,2A/3A,Ф5×20

250V,2A/3A,Ф5×20

Dimension(WxDxH)

130x150x200mm

130x150x240mm

NetWeight

2kgs

2.5kgs

Instructions for Use:
  1. Fill the sterile container with clean, dry glass beads. Please don’t use any fillers or liquid inside the container. The standard filling depth is around 20mm.
  2. Turn on the power switch & allow the sterilizer to heat. After some time the vessel temperature will reach the set temperature.
  3. Now the sterilizer is ready for use.
  4. Insert as many as possible drying instruments which need to be sterilized to glass beads.
  5. Don’t touch the glass beads or the sterilization chamber before it reaches room temperature ! Avoid burns !
  6. Turn off the power switch & close the cover after finished to prevent dust entering the chamber.